Swage Standoff
Standoffs & Spacers · swaged standoff · clinched standoff · press-fit standoff
Definition: A swage standoff is pressed (swaged) permanently into a panel hole, providing a fixed threaded mounting point — no nut on the back side.
Anatomy
■ Body■ Internal thread
Governing standards: Manufacturer specified (no universal standard)
Common Sizes
| Inch | Metric | Head width | Head height |
|---|---|---|---|
| 4-40 | M2.5 | — | 1/8 to 1/2 long |
| 6-32 | M3 | — | 1/8 to 3/4 long |
| 8-32 | M4 | — | 1/4 to 1 long |
Representative sizes. Full dimensional data lives in the standards listed below.
Grades & Strength
| Grade | Material | Tensile (psi) | Marking |
|---|---|---|---|
| Brass / steel | varies | — | None |
| Stainless / aluminum | varies | — | None |
Materials
- Brass
- Steel
- Stainless steel
- Aluminum
Pros & Cons
Pros
- Permanent, strong mount
- No back-side access needed
- Flush finish
Cons
- Needs a press or swage tool
- Panel thickness must match
- Not removable
Typical Uses
- Sheet-metal chassis
- Electronics enclosures
- Panels
- PCB mounting
Alternatives & Related
- Hex Standoff — Removable threaded standoff
- Round Standoff — Screw-in cylindrical spacer
Where to Buy
Affiliate links — we may earn a commission at no cost to you.
FAQ
What is a swage standoff?
A threaded standoff pressed permanently into a panel hole, giving a fixed mount point without access to the back.
Swage vs screw-in standoff?
A swage standoff is pressed in permanently; a screw-in standoff threads into a tapped hole and is removable.